MT 10
- Belt drive
- Moving Coil cartridge
- Illuminated speed meter
With tracking force, anti-skate and cartridge position preset at the factory, the McIntosh MT10 Precision Turntable delivers high performance LP playback with minimal set up. A custom tonearm features a rigid, dural-aluminum arm-tube gimbaled in two sapphire (horizontal) and two ceramic (vertical) bearings for the least possible friction. A .5mV moving coil cartridge is included, and features an ebony body with an elliptical stylus. Enjoy a new level of music with the MT10 turntable.
SPECIFICATIONS
| CARTRIDGE SPECIFICATIONS | - Cartridge Type: Moving Coil, Low Output
- Output Level: 0.5 mV at 5 cm/s
- Load Impedance: 400 to 500 Ohms recommended
- Frequency Response: 20Hz to 50kHz
- Channel Separation: Greater than 30dB at 1Khz
- Compliance: 6 x 10-6 cm/dyne
- Recommended Tracking Force: 2.4 g
- Channel Difference: Less than 0.3dB at 1kHz
- Total Mass: 11 g
- Stylus: Elliptical Diamond
- Cantilever Material: Aluminum
|
| TONEARM SPECIFICATIONS | - Bearing: Sapphire and Ceramic
- Arm Tube: Dural-Aluminum
- Counterweight: Eccentric
- Adjustments: Vertical Tracking Angle, Antiskate, Azimuth
|
| TURNTABLE SPECIFICATIONS | - Playback Speeds: 33-1/3, 45 and 78 rpm
- Motor Type: DC Brushless
- Speed Control: Electronic w/ braking feature
- Platter: Silicon Acrylic
- Platter Bearing: Magnetic Suspended Ceramic
- Signal To Noise Ratio: 41dB - 44dB
- Wow & Flutter: 0.10% - 0.15%
|
| CONNECTIVITY | - Stereo Outputs Unbalanced: 1
|
| CONTROL | - Power Control Input: 1
- Power Control Output: 1
- Platter Light: Yes
- Speed Control Fine Adjustment: Yes
|
| GENERAL SPECIFICATIONS | |
| WEIGHTS & DIMENSIONS | - Unit Dimensions (W x H x D):
17-1/2” (44.45cm) x 8-13/16" (22.38cm) x 21" (53.34cm)Note: Tone Arm Height will vary depending on the type of Cartridge installed. - Unit Weight: 42 lbs (19 kg)
- Shipping Weight: 63 lbs (28.6 kg)
|
